|
|
|
|
|
|
|
|
|
|
|
Related Items
Our Platinum system allows you to LEVEL (not just stabilize) your bumper pull travel trailer.
You can extend the cylinders in pairs to lift the front, rear or side or operate them individually in order to get the trailer level.
Your standard "electric stabilizer jacks" powered or crank type, cannot actually lift the trailer, they stabilize by only making contact with the ground. So the RV still has the "body roll" effect due to the suspension still being a factor. This leveling system can support the entire weight of the trailer, so when these are deployed it makes it rock solid!
Measurement: Rear frame height (ground to underside of floor just behind rear axles, trailer parked level) should be between 25"-30". If your measurement is taller, we have longer cylinders for you, just call for more info or to order.
This system is powered by a central hydraulic power unit that is mounted under the RV on the frame with the cylinders, no need to take up any valuable storage space.
Check frame height: Measure near axles, the undeside of the floor should be 25-30" to the ground for this kit, if yours is taller call as we have many options.
Front cylinders are recommended on the exposed A-frame of the trailer and have 18" of travel. Rear cylinders just behind the rear axle, with 14" of travel.
Features:
Four double acting hydraulic cylinders (power up/power down) made at our facility in Michigan.
Powered by one marine grade power unit out of Minnesota.
Four 100 square inch pivoting footpads
Battery cable, mounting brackets (weld or bolt), generic hydrualic lines, hardware, etc.
*System kit received may vary from the above image. Refer to the installation manual.
