|
|
|
|
|
|
|
|
|
This kit requires welding for installation. A Bolt-On version for the Ford E-450 Chassis can be found here.
- Simple, one touch operation for fully automatic leveling of the vehicle or trailer.
- A single Central Hydraulic Pump - an American made marine pump & motor wrapped in a steel housing - allows the unit to be mounted outside in the elements so it does not take up storage space.
- All-Up safety feature signals if one or more of the cylinders are not fully retracted before you drive off.
- Manual adjustment feature that allows you to operate each cylinder individually.
- Four powder coated cylinders made at our facility rated to lift 8,000 pounds per cylinder and come with a LIFETIME CYLINDER WARRANTY.
- All necessary components and hardware for a complete installation!
Attention: Vehicles 5 years old or older, Measurement Required: Underneath the cab driver's area, locate the control arm mounting bracket for the front axle, just rearward of this bracket measure from the bottom of the vehicle frame to the ground (parked on level surface). If this measurement is below 15" use the Ford E-350 part numbers as they have a shorter front cylinder for better ground clearance. If this is not done, the cylinders may be swapped out in the installation process time frame (fee applied).
*System kit received may vary from the above image. Refer to the installation manual.
Increase your systems lift height & footpad diameter with a set of SnapPads! (#M27807-4)
Need to extend your Hydraulic Hoses? Call and order a Hydraulic Hose Extension Kit! (#M52190)
